How to Build a Smok Pen
The Smok Pen is a revolutionary vaporizing pen which allows for a write-to-write experience, whilst you are away from home. This is because of the unique design of the pen. It has two tanks, one smaller than the other, that house the e juice and charged batteries. Once the user really wants to write, he just places the pen into the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as though he could be writing under a black mirror.
One of the biggest attributes of the Smok Pen is its ability to charge while it is on your own desk. Simply because the coils on the Smok Pen are designed in a way to help keep the e juice from dripping onto the table or somewhere else. This is because of the 0.3-ohm coil that is placed inside the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents will not affect the writing process. This is because the electronic circuitry has protection built-in so that it will never be affected by extremely low voltage electric currents.
The Smok Pen can be charged internally with a charger or via the USB connection that comes with it. Since the electronic circuitry includes a safety barrier built in, this means that there is no risk involved when charging the device through the computer. The Smok Pen includes a charging capacity of sixteen 50 mah batteries, that is ideal for all pens that use a couple of batteries.
To keep the Smok Pen doing work for an extended time frame it is important that you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that is available and may eventually bring about the device malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. If you feel that your battery isn’t getting the vapor it will, remove the pen from the energy source and let it cool off for some minutes.
The Vape Pen Battery fire button on the Smok Pen is located in the bottom right corner of these devices. The fire button has an orange light, which indicates that it’s on. It is possible to press this button to activate the electronic heating element that may permit you to vaporize the oil. After you have done so you can remove the coil from the holder and place it into the holder and place the Smok Pen in to the airflow chamber, that may cause the heating element to start heating up and burning off the wick.
When the coil is removed from the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they start to turn blue, that is the indication that it’s ready for the pen’s battery. Ensure that you place your sub-ohm in to the chamber before you push the fire button. If you do not put the coil into the airflow chamber then your oil will leak and cause the leaking of e-juice.
Before you put the battery in to the pen, you must ensure that you have disconnected all of the leads. Then you need to take out the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a little cotton bud, to help you eliminate the leak. Then reattach the cap back again to the Smok Pen and you are prepared to place the battery into the pen.
The ultimate portion of the construction process is the adapter plate, which fits into the Smok Vaporizer’s USB port. This plate allows you to charge your e-juice during your computer, so long as you have an adapter for USB connection. I like this part since it allows me to charge my entire kit simultaneously without worrying about running out of power or constantly running out of e-juice.